Osram HALOTRONIC-COMPACT – HTM, HTN Bedienungsanleitung PDF herunterladen

Electronic transformers for 12 V

halogen lamps

• Optimum lamp life

• Compact for small spaces

• Reversible switch off in case of short-

circuits, overload and overtemperature

• Dimming on the primary side is

possible. A corresponding dimmer

has to be used (suitable dimmers see

table)

Connecting the transformers to the

lamps

• Ensure that the lamp load is within the

output range of the transformers (see

table)

• Transformers can be connected in

parallel on the primary side (fig. 1a)

• Do not connect the transformers in

parallel or series on the secondary

side (fig. 1b)

• The maximum load of the transformer

can be connected to any of the lamp-

side terminal pairs (except HTL 225)

Wiring

• In accordance with the EN 60598

standard, the recommended

connecting cables (see table) must be

held firmly by the cable clamp to

prevent it from being pushed or pulled

• Secondary side: cable length maximum

2 m, minimum 0.3 m (fig. 2 and 3)

• To prevent radio interference keep lamp

cables as short as possible, keep them

away from metal surfaces and keep

them separated as far as possible from

mains cables (fig. 2 and 3: angles ≥ 90°).

Do not route cables along the

transformers

• When using single leads of a cable,

secondary wires have to be twisted

in pairs

• For units installed in fixtures the

luminaire manufacturer is responsible

for RFI-compliance

Temperatures

• Avoid high temperatures. Do not place

the transformers close to the lamp

(minimum distance 0.3 m). Maximum

permissible ambient temperature must

not be exceeded (see table). Make sure

there is adequate space to avoid a

build-up of heat. In critical installations

the temperature at t

has to be

controlled

Caution

•

Transformers must be installed by a

qualified electrician

• Electronic transformers are not suitable

for any other load than low voltage

halogen lamps

• No switching or dimming on secondary

side

HALOTRONIC

1. a

1. b

correct incorrect

35 W

100 W

HALOTRONIC

105 W

HALOTRONIC

105 W

HALOTRONIC

105 W

35 W

4. Wire stripping (see table)

Prim. Sec.

Optimum

area for

primary cable

Optimum

area for

secondary

cables

230 – 240 V

50 – 60 Hz

max. 2 m

min. 0.3 m

HTM 70

HTM 105

HTN 75

90° 90°

Optimum

area for

primary cables

Optimum

area for

secondary

cables

Prim. Sec.

HTL 105

HTL 225

HTM 150

max. 2 m

min. 0.3 m

90°

mains

unit

not used

10 W

120 W

HALOTRONIC

105 W

HALOTRONIC

105 W

HALOTRONIC

105 W

HALOTRONIC

105 W

1 2

HALOTRONIC 1

Inhaltsverzeichnis

Seite 1 - HALOTRONIC

Electronic transformers for 12 Vhalogen lamps• Optimum lamp life• Compact for small spaces• Reversible switch off in case of short-circuits, overload

Seite 2

NYM(3x1.5) mm2H05VV-F(2x0.75) mm2H03VV-F(2x0.75) mm2H03VVH2-F(2x0.75) mm2HTN 75/230-240 I HT 120/230-240/12 LF HTL 105/230-240 HTL 225/230-240 230

Kommentare zu diesen Handbüchern

Keine Kommentare

Osram HALOTRONIC-COMPACT – HTM, HTN Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Beleuchtung Osram HALOTRONIC-COMPACT – HTM, HTN herunter. OSRAM HALOTRONIC-COMPACT – HTM, HTN User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Beleuchtung Osram HALOTRONIC-COMPACT – HTM, HTN