Osram HF LS LI Bedienungsanleitung PDF herunterladen (Seite 12)

3.3 Setting vibration sensitivity

Set vibration sensitivity to avoid erroneous triggering caused by vibration:

1. Press the [PROG] button (VLP) to start programming mode.

2. Press (SP) the button [2] (inner ring segment on the remote control) to select conﬁguration

of vibration sensitivity.

3. Set vibration sensitivity (see table) by pressing (SP) buttons [15] to [20].

4. Exit programming mode by pressing (SP) the [PROG] button or exit automatically 60 sec-

onds after the last detected movement.

Vibration sensitivity Button event

Vibration detection off Press button [20] (SP)

Min Press button [15] (SP)

Mean (works setting) Press button [16] (SP)

High Press button [17] (SP)

Very high Press button [18] (SP)

Max Press button [19] (SP)

Table: Vibration sensitivity settings

Important note:

After installation or after modifying the position/realigning of the sensor, setting vibration sensitiv-

ity is mandatory before normal motion detection is active.

3.4 Sensor LED signals

LED display (red / green),  4 (3):

LED signal Meaning

Green LED ﬂashes Motion detected

Green LED illuminates continuously Holiday mode active (motion detection

temporarily deactivated)

Red LED ﬂashes 3 times IR signal of remote control received

Red LED ﬂashes 1 time Vibration detected*

Red LED illuminates continuously 100h burn-in active

Table: LED signals

3.5 Conﬁguration of DALIeco control unit

 separate instructions

4 Accessories  1b

(1) 4p4c connecting cables,

pre-assembled connecting cable, (50 pc. pack)

0.25 m: 4008321660145 0.5 m: 4008321660152

1.0 m: 4008321660169 2.0 m: 4008321660190

(2) DALIeco control,

2-ch. DALI control unit for installing in luminaire and ceiling, 4008321988645

(3) User remote,

user remote control, 4008321826435

(4) Master remote

Conﬁguration remote control, 4008321988669

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Keine Kommentare

Osram HF LS LI Bedienungsanleitung Seite 12